Search results

My hot and cold supply is 10mm plastic and my tap has come with 15mm flexi pipes as pictured. What’s the best way to connect these? Thanks in advance.

So I have a switch that isolates my dishwasher, washing machine and fridge freezer that I needed to move. All 3 cables from the appliances run down from above as does the power input. Also wired to the input is another cable that runs about 20 inches to a double socket off to the right. The...

I can’t for the life of me find a washing machine waste connector and trap. It’s going to a tee and then into the stack. There is no sink waste so the no need for another connector. Is there a specific part that I just can’t find or am I limited to the trap with the long waste pipe and...

this is the waste from my utility room. Had a sink and washing machine connected. The main pipe goes into the main soil stack. But the smaller pipe goes up in the same direction as the stack towards my boiler. There is a similar pipe coming out of my boiler which I’m assuming is the pressure...

Just ripping out my kitchen and my mains water stop cock looks like this. Is that right? Or can I fill this great big drafty hole? If so what’s the best way? Thanks.

I have a gas hob I no longer want as I’m replacing it with an induction hob when I fit the new kitchen. I’ve attached a pic of the isolation valve tap that goes to the hob. Can I simply turn off the supply at this tap and disconnect the gas pipe to the hob or is this something I need to...

I need a 1000mm straight corner sink kitchen unit to fit my kitchen plan. The door on this unit is 500mm and the worktops will be 600mm and joining at the centre corner of the unit. Is it possible to fit a standard sink to this corner with 600mm bowl to bowl measurements or will I need a...

I have this switch panel for integrated dishwasher, washing machine and fridge freezer. It’s directly above where I want to fit the hob in the kitchen refit I’m doing. I think regs require integrated appliances to have an isolation switch. My question is. Rather than rewiring the switch to...

I’ll be fitting a new kitchen soon and my hob will be moving. The new location for the hob will be underneath my current 3 gang kitchen switch panel (Washing Machine, Dishwasher, Fridge Freezer) and too close to a current double gang (pictured) so both will need moving about 700mm to the right...