Search results

Not going to be paying the £50 subscription this year, they are taking the p1ss... Any good alternatives out there? I have a Hikvision CCTV system and seem to remember they offered one, but does it allow remote playback?

I am wondering if anyone can advise which fence section(s) are likely to be mine? I am the homeowner. See attached. All sections could do with being replaced to be honest, most of the posts are rotten at the base and have had extra wooden support posts fitted. During storm henk the wind managed...

A few years ago i replaced my up and over garage door with a manual insulated roller door. At time time the best thing i could come up with to close the gap between the slats on the roller part of the door and the opening was to fit a brush strip. Is there a better way?

Hi, I have a number of GJA-000x sensors on my system. I have had two that have reported low battery events as tampers and as a result thrown my system into alarm. I have read on this forum that there were a number of these sensors that have this firmware bug. I have changed one of my sensors...

Hi, I hae been using the Texecom app for around 1yr, recently upgraded to the new version 2, all was working ok. Last night i added a few extra sensors to the alarm, did not change anything else. When i now try and log in via the App, i get a "panel code not found" message with a "please...

I recently upgraded the iOS Texecom app to v2.0.20 I notice when i look in 'Rooms & Devices', under security only certain sensors report back a temperature. All the ones that do were added to the panel back when i was using the old app. Since using the new app i added some more sensors to the...

I need some tiles (or as close to as possible) that match my existing ones in my Kitchen. I have looked at various places and cant seem to find the exact tiles. The tiles have been down perhaps 15 years or so, it may be the case they are not manufactured any more. Any help would be greatly...

Hi, I dont see any of my zones when i access the RF devices page.. any ideas why? I am running Wintex_7_2_2_1 (latest), selecting Diagnostics button then navigating to Control Panel > RF Devices. If i select Network 1 > Ricochet XP01 Devices i see all of my wireless devices as i should, just...

In Wintex i have an option for each zone to configure a chime tone. There are 4 options, silent and chime tone 1,2 &3 no matter which of the three chimes i select the keypad and alarm unit only ever chime the same tones. Are the three different chime settings suppose to omit a different tone?

Hi, In my log for the Texecom Premiere Elite i get the occasional following error reported: 117 22:14:00 01/06/2020 INVALID GROUP . . . . A Corrupt Event Found What could be the cause of this? Cheers

Hi, I am trying to set my Texecom Premiere Elite so that i can use the tag to set the alarm but the alarm can only be unset by entering a valid user code (not via a tag). I have a key box nearby the alarm panel where everyones keys are stored, each persons keys has their own tab for the alarm...