Search results

I have a quick question, I am getting my rendering done on my extension and wanted to clarify I can do what I think I can do for the outside lighting. The fuse board location is on the first floor as shown on the drawn picture. I have four post lights that I want to position as shown by the...

I have a T8 ballast to replace in my strip light. I took it down hoping to replace it with exactly the same part. However I don’t seem to be able to locate the particular one that’s in there. I’m not sure which spec I have to be careful to match to ensure it’s the best alternative and make...

Long story short, my builder forgot to put the ducting in for my downdraft extractor. Have managed to channel cut underneath the concrete to get it all in and almost there! I have a Smeg SP150 flat channel ducting kit. There are a couple of parts that I don’t really know where they are meant...

Does anyone know where I can source some M5 8mm screws, literally need a few? I have purchased multiple lots online but the heads are too big (as in too wide). This is for a Crosswater radiator. The screw rebates and therefore the head being too big on the ones I’ve ordered is an issue. I...

Hi, I have my mains pipe coming into the side of my house. I am going to have the adjacent wall studded out and therefore want to hide the mains pipe behind it and put on a low profile stop tap. My question is that it is approx 10” further along the wall than needed. Is it ok to make a channel...

Hi, please can someone help me here. I’ve had my garage converted to a kitchen. Floor was lower in the garage compared to the level of the existing house. Anyway, I am having an island with a downdraft extractor. I have UFH installed and the builder has forgotten to put in the ducting for the...