Search results

Hi guys, In need of some advice here. I had to repaint a wall and there were a few bubbly areas where the paint had bubbled and cracked. As I started to prepare the wall, the paint was just peeling away in large sheets back to the plaster. The bare plaster is dry and there are no damp issues...

Hi, I have a loose light switch plate. I am unable to tighten the screws because the thread is worn on the metal box which is embedded into the wall. I am unable to replace the metal box as it has been tiled over. Any ideas what I can do here? Happy to supply photo if that helps.

Hi guys, I had some horrible wallpaper which I stripped which came off quite easily. On part of the wall it also took away a couple of layers of paint and went back to the plaster. This paint came away easily in this area but now I can't get the paint off the rest of the wall using only a...

Been working fine up until now, but now it's just stopped working. The unit has an on/off button and a boost button. The lights on both of these buttons work when you switch them on and off but no water comes out. You can hear the pump or whatever it is whirring away when you switch it on...

The anti-freeze level keeps going down and I am putting about half a litre of ready mixed anti-freeze every week or so. When the car is parked I have noticed a wet patch on the ground underneath the radiator (which is definitely anti-freeze) but the garage has pressure tested the radiator and...

I'm having problems with my 2001 Ford Fiesta. It's fine until I go on the motorway and start doing over 70mph, then it starts blowing out loads of hot air through the air vents even when they are closed and the control is set to cool. I'd appreciate it if someone could point me in the right...