Search results

Just one point.... The instruction manual says to use 2.5mm T&E !

Hi Guys I think that it will be notifiable as I am replacing an old cable that hasn't been used for years so that I can go back to electric from gas. Just needed to clarify.

Thanks for the rapid replies guys. Is it permissible for me to do the work and then have it inspected and certificated to part p

Hello all... Can anyone please tell me if 6mm Twin & Earth is suitable to run a 4.12KW Baumatic Double Oven and what mcb I should use at the CU. Thanks

I'll definately admit that until I unravelled all the wiring I was confused and could'nt see everything. Now on the other hand it all seems to be a lot clearer (I hope). S/L should be the call for heat from the cyl stat, and P/L should be the connection currently tied in with the pump live. If...

My existing setup is a mish mash of connector blocks so thats why I bought a wiring centre. The new pack is a Drayton Sim-p-l Fit, It consists of a Tempus 7 programmer, wiring centre, pre-wired cyl stat, pre-wired drayton 3 way motorised valve and a room stat. The motorised valve and the cy...

Here we go... Yellow- cylinder stat Green/Yellow- Earth Blue- Neutral Black- Live (linked to central heating pump) Red- Live (from timer/programmer) Any ideas how that translates to L E N S/L P/L (i know E is earth) Cheers Rick

Hello again.... things are looking a little clearer now, the fuelsaver DOES have overrun and I have 5 not 4 cables running from it (red blue black grn/ylw and yellow) now I just have to work out what goes where. Are these wire colours industry standard Rick

I have studied the wiring diagram on the casing and it does show boiler overrun, but I am wondering why I've only got the one extra wire when I should have 2 (s/l & p/l). What could happen if I connected the live. neutral and earth to the wiring centre and left the yellow disconnected ? Rick

Thank you for your prompt replies... I can understand that the yellow from the boiler could be a call for heat, but there is no option on the wiring centre (unless it goes to the s/l on the boiler section). I have also tried to find the manual online but as yet cannot find one, so I don't know...

Hi...This is my first post so....Hello I have a Glow-worm Fuelsaver mk2 and have just purchased a wiring centre to tidy up the mess I currently have. This is the problem, the circuit board asks for live neutral and earth for the boiler, which is fine, but the boiler also has a yellow lead and...