Search results

  1. A

    Copper pipes in solid wall

    Apologies for asking this question again - looking at previous posts this has been covered already but there seems to be a mixture of answers. I am planning to install a wall hung sink in the bathroom, which is on a solid (outside) wall. I was planning to chase out the wall, insulate the...
  2. A

    KITCHEN UNIT LIGHTS

    Before I start - I am in Scotland, so Part P does not apply. I want to fit 5 20w lights under the kithchen wall units. I have 2x 10-60va transformers - but what is the best way to connect them so all the lights are operated by the same switch? 3 lights are in 1 transformer with the other...
  3. A

    Oven Installation

    I am planning in fit a 3.7kw oven. Hob will be gas. Planning to run 2.5mm cable from 20A MCB to 20A DP switch (placed above worktop near hob). - What type of cooker terminal outlet do I need? I've only seen 45A cooker outlet or a 13A FCU with nothing in between. - Where is the best...
  4. A

    RCD tripping

    I recently rewired upstairs lighting circuit (in Scotland so no Part P legislation). 1 circuit for upstairs lights, 1 for bathroom/ shower lights (RCD protected). At first the RCD tripped when I connected the new upstairs circuit. In attempt to find fault I connected a new cable straight...
  5. A

    Terminating SWA

    I'm running 6mm^2 (3 core) SWA to my garage and am looking for some advice on how to properly terminate it into a plastic CU. I have the appropriate glands and understand that it would be better to terminate it into a metal box and then connect it to CU. Can someone please advise on the...
  6. A

    Garage electrics

    I know this topic has been done to death but after searching I can't find an answer to my problem. I am intending to run a circuit to my garage about 20ft from cu. Running from spare 32a MCB in CU (RCD protected). Power for fridge, tumble dryer, some light power tools. Intending CU...
Back
Top