Search results

I have an issue with this Siemens Dishwasher SE25M275GB/36 Upper Spray Arm not turning . Everything is working except for this. Spray arms are clean and no blockages , manifold clear too Motor was siezed but i unsiezed it and now it works fine . any ideas ???

Hi I have come across a confusing intermittent problem on the machine mentioned in the title switch the dishwasher on and it Drains Fills the motor starts , then it just stops, leaving inlet and otlet light flashing checked the motor it works fine and no debris inside the housing the...

Got a Britannia 90cm Range Cooker has gas burners and 2 electric ovens , very popular version of their cookers i believe as i have seen many is approx 10 years old or so, and has served us great no sign of any model number on the cooker anywhere the smaller oven on the right has developed...

i am trying to fix my whirlpool wd1000 washer dryer it does all the cycle from start to finish except the drum doesn't turn belt is attached appears to be a brushless motor any suggestions ???

Hi I need some advice on safety for my outside shed i have had it for 2 years so far with no issues, but i would like to make it proper safe it is large and designed to store plates & equipment in but i also have 5 fridges & 1 freezer in there 1 dishwasher also a socket for...

WD71 hotpoint washer dryer i am testing the thermostat / fuse its the square black box one on the dryer section tested the two spade terminals for resitance it shows '0.00' i assume that this means it is ok and continuity is present allowing current to pass through thus allowing...

I have an indesit washing machine w 143 uk the on off button flashes 6 times at the end of the cycle any ideas what i should look for

When you replace a PCB second hand to a washing machine or Dishawasher is it as easy as finding the equivelent replacement and then replacing the faulty one carefully.

Hi i have whirlpool AWO/D 4505 it runs the rinse only , drain only , rinse & spin only programs no problem but when i put it on any of the washes the service light flashes RED also rinse also spin & drain green lights are on any ideas

my Beko WMA 1512 w has a fault when you switch on the dial rotates from number 1 to number 5 then water enters the machine, it washes for a bit , i didn't feel any heat in the bowl but not sure if it would anyway is this the pcb or the program switch or both is there any way of testing...

My Hotpoint WD71 has developed a fault it says "check water outlet" i have changed pump changed wire from pump to pcb undone down pipe from drum and flushed out checked outlet pipe not blocked and held it over the sink manually i am now confused ???

i have a hotpoint wf840 can i run it on cold only but without damaging anything on the machine i will have the hot fill tap capped can't see anything in the manual that says i can i feel i'm asking a silly question but answers are very easy when you know the answer

my hotpoint WD71 developed a strange fault as soon as you start the cycle the water fills as normal the drum starts to turn a bit as normal but when the drum turns its very eratic and much much faster than you would want, not quite 600 spin speed but definitely faster than usual the motor...

my Hotpoint WD71 has a new fault the infobubble display say close the door but i think the circuit board in the facia display is the guilty party. because when you close the door it seems to shut ok and hasn't been slammed and has no signs of a breakage and also when you switch off...

just fitted a new set of bearings to a Hotpoint WF840 cost me £18 and a few grazes the old ones were disintegrated and drum completely siezed :shock: :shock: was a mission but do-able from an amateur like myself and it works nicely too :shock: :D :shock: :D :shock: :D heres...

hi my hotpoint ultima wd71 front panel buttons are NOT doing what they say for example if i press the drying button the info display shows that i have pressed timesave button etc etc which part is most likely faulty

Hi I have taken the lid & sides off a bosch dishwasher what is the best way next to access all the parts

Hi All i have one of the versions of the common bosch dishwasher (60cm) it is stuck on pump so i took the sides off to check for a leak yes there was one but i assume the flood sensor is the 5" diameter polystyrene piece attached to the metallic push button piece. so i then run the...

Hi I have an Hotpoint Ultima WD71 washer dryer it doesn't seem to be heating the water but the fault code' E14' is not neing displayed the display says 'heating' how would i know if the machine is heating, i touch the plastic porthole cover when on 95'c but it has no heat thanks

i have a comedy fix to tell people i recently fixed my whirlpool amg329 washer dryer would not completely empty after final spin so i took the big rubber pipe from the drum to the drain house it sounded like a money bag i squeezed in total £14.74 in loose change now the machine is great...