Search results

Hi, I need to close a gap from a knock out of a window to a French door. I can see the DPM as blue in the picture which will feed up the wall. Do I just need to overlap some more DPM to take it up to the level of the French doors and then fill? Is it a 4-1 mix with agg I should use please...

Hi, had some work done on the house so have drained the central heating a few times and had some pipe work done. all back together and all works fine apart from one radiator. I’ve taken it off and flushed it. I’ve changed the valves to new ones. But no water is coming through the valves...

Hi, nice got a couple of gaps to fill after window knock throughs for new doors. I have DPM and Visqueen. Which one would be better to use please? Also, cement mix should be 4-1 with some 10mm stones? finally, do I need closers on both or just go ahead with the plasterboard? The one with...

Hi, not sure if this is the best forum or gas. had an electrician in to rewire a kitchen. He removed a lot of ‘old’ wiring including that of the old thermostat as we have hive. However , now the pump does not come on for the CH but does for the hot water. anyone any idea of what might of...

Hi, We have a smelly shower drain (urine) and I think we need some sort of U bend or air lock drain instead of the one we have on it. the sink which is connected to the same run into the soil pipe is fine and obviously has a u bend. is there something I can fit instead of what is on there...

Hi, I have a vertical 4 inch waste pipe I need to make a rodable access to. Getting access to the full pipe is a little tough. Any ideas on solutions or is it a case of cutting two points and adding a new section with access? Thanks.

Hi, I’ve had a little search but would still like some advice please. Got a new extension with a pitched roof and breathable membrane. About to order the insulation board for between the rafters but want to make sure there is enough air ventilation. They are 7 by 2 inch rafters. Was looking...

Hi, was hoping to get the whole of the ground floor done with LVT but after lifting up a ceramic tile and some of the engineered wood that is done now I’ve found that everywhere has these old stuck down vinyl tiles. They are not coming off. Is it possible to screed over it or do I reconsider...

So Velux are stating long lead times for windows. I'm looking elsewhere so Fakro and Dakea. I'm after three windows and two of them being 66x140 which unfortunately Fakro and Dakea don't do so will have to do 66x118. I also thought those two would be cheaper but by the time I add in the...

Hi, I'm having to deal with the 25% glazing rule. My limit is 11.5m2 but I'm at 19m2... I'm looking at the level of insulation in walls, floor and vaulted roof. We also have existing solar panels and solar water heating - do they help at all or don't they matter as they are existing? Other...

Hi, I am trying to maximise the pitch on a single story extension. I've looked but can't find what the minimum height of a roof plate is. Default I was going with 100mm but can this be less? 170 x 45 rafters are being birdsmouthed onto it. Extension is 4m out by 7m wide. Any help would be...

Hi, I'm trying to find a cost effective solution for my proposed 12.5 degree pitched extension roof. Velux with the appropriate flashing are crazy expensive. Has anyone used these and could give an opinion please? Thanks for any help...

Morning, Does anyone have experience of composite doors and bifolds made by this company please? Thinking of a purchase but can’t find much out about them regards reviews by experts. Thanks.

Hi, I'm having a 7.5 x 4m 30 m2 extension built. I'm going to project manage it myself and have a builder lined up at a day rate (with a labourer), he trusted guy who has done other work for me. Fully aware of the potential issues of paying a day rate vs job but I'm willing to take that risk...

Hi, I've searched but I mustn't be using the correct terms. We are having an extension done and some existing patio doors replaced. Costs are racking up quickly and we need to save some money. I'll be getting a quote from the builder from his usual windows guy but want to be informed. We...

Hi, Just pondering the new electrics for a new kitchen. Will get a Part P electrician in anyway but I like to be informed. There will be a 7.4kw induction hob which will have a 6mm dedicated feed. There will also be two Neff 2.99kw ovens. It says they can be plugged in or hard wired. My...

Morning All, I'm looking for a bit of advice from people who know much more than me please :). We are wanting to extend the house. Single story to the rear. I've drawn it out as per the picture. Originally we were also considering a 2 meter width single story side extension too but with...

Edit: added another picture. Would prefer to buy a new insert, can anyone please advise which one it is? Hi, I’ve got a dripping hot side mixer tap. I assume I can fix it with a washer? Before I try to fix it and take it apart and maybe break it, any guidance on what the issue is, what to buy...

Hi, I'm looking at getting an orangery built on the back of the house and want to make sure I'm educated regards the drains to make sure the builders do the correct thing (sure they would be like to be in the know). We have an inspection cover right in the middle of the proposed building. It...

Hi, I have searched but can't see anything recent. I'm re-painting my banisters. Used Dulux water based gloss a couple of years ago but it hasn't fared well and looks worn from hands and rubbing. Did a bit of research for something better. found Sikkens Rubbol Satura Plus. What do people...