Search results

I have just bought a monobloc basing mixer to replace a broken one. It came with 2 braided flexible tails. The male fitting to my new tap is larger than on the old tap, so I have to use the new 12mm tails. The problem is that the older tails had a female threaded connector at the non-tap end and...

I have a mono mixer on a bathroom basin. It is about 150mm tall, cylindrical and with one of those turn and tilt single-lever top. It has stopped mixing (hot only now) and is difficult to shut i.e. Takes some jiggling to stop the flow. I am reluctant to buy a replacement because it will be...

In the absence of a CH boiler right now, I'm depending on an immersion heater to heat the hot water in the cylinder. The immersion is working but I'm getting no hot water. The immersion is situated on the top of the tank, down vertically into the tank. There is a hot water vent pipe right out...

I have a 7 year old Potterton Suprima 80 and recently it stopped working suddenly. Power and light were still on at the timer switch/controller but all lights on the boiler went out. I found the fuse on the PCB (T3.15) and sure enough it had blown. I replaced that fuse twice(!) and both fuses...