Search results

cheers for that.. esi have just confrimed that as well now they are open.. manh thanks again

yes..

almost new boiler and new controls. all 'works' a treat however the controller isnt wired up right as heat is on all the time.. how should it be wired? boiler has E N L rt, controller has E N com no nc?

old boiler well maintained in clean condition serviced by me every 12 - 18 months. Pilot lights easily and without a demand for ch or hw will stay alight indefinately. once heat is called for boiler will only stay alight for between 20 seconds and 8 minutes no matter what temp boiler is set to...

head scratching on this one... boiler in good condition serviced every year etc. water pressure kept rising on ch so all normal checks done on system expansion vessel seemed to be ok at 1 bar absolutely zero water expelled from Expansion vessel valve, water circulates freely around rads, all...

i'm a Ch installer fitting W/b exclusively and i fit the Salus 7 day wireless programmer everywhere, i 've fitted over a hundred without a problem and never being raised as an issue on re visits /services.. and great value to.

in an ideal world this would be a might be a 4- 6 hr job. boilers already on wall all pipework connected.. HOWEVER have you a route for blow off, and the same for the condensate, have you conected the condensate sump ( that would be illegal by the way) have you a hole for the flue, have you...

ask a corgi reg engineer to visit and make the appliances safe to use. then you'll be safe and in no doubt what so ever. rvi

got to re think my charging if your getting 84 quid for just dianosing a problem..

get the key slide it in ( it should go easily then push gently so that it seals,) then turn it 90 degrees so it locks in place. to the left of the key youll see a small white cube approx 1cm sq. turn this to the left youll hear water running keep an eye on the guage and stop when it is just...

well i'm off to Norwich.. if you can get customers paying 60 plus vat for the first hour then charge by the half hour for additional time. in the blood and guts world ( rochdale) i get laughed at for wanting 35 an hour and they wont pay for anything beyond the hour boiler swaps with a bit...

absolutely the right thing to do, i have seen flues that work great in summer but come winter and the wall/ flue is cold no chance. i 've seen a perfectly servicable bbu that has been in place 20 years with a traceable and complete service history fail a flue test on the day because of high...

had a saniflo slim for 3 months, although it started ok making usual swoosh every couple of seconds now it vibrates to a point of looking like its about to shake itself to bits.. clues or do i just cal out saniflo under the guarentee.. should have said its a sani slim and looking after a...

customers are now insisting that i dont put stats in the hall and that they go in the lounge ( where they spend most of the time) so no trvs in the lounge..

guilty as hell but you have to question the purchaser.. 1800 is not peanuts ( fitting a worcester 24i for £1950 tommorow) so its not far off the going rate for a top class boiler in rochdale....

not the fuse(swapped even thou looked good and tested sound), not the pcb (swapped), not the pump(swapped head for known good one..)

im in rochdale if that any good to you.

for goodness sake calm down.. what does it say in the paperwork he left you.. what make and madel boiler is it did he complete and leave with you the benchmark document for the boiler they will tell you exactly what he fitted.. as for not paying anything at all you should calm down...

yes and so did i but with a new pcb same fault.... happy though that i'm not the only one who was drawen to the same conclusion..

yes and so did i but with a new pcb same fault....