Search results

Hi Re-surrecting an unfinished project in an 1820s farmhouse where i submitted a Building Notice in Sept 2007 for a loft conversion to make it into two habitable rooms. How can i establish the spec for insulating beneath the rafters ? rafters only 3" x 2" so i will need 50mm air gap to start...

Hi folks, hope you can help me here dishwasher flooded at the base, when power button is pressed NO lights come on. Have pulled the machine out tonight, scooped the water out of the base tray, checked the fuse in the 3 pin plug all ok. checked anti-flood device, all bone dry smelled the motor...

Hi Worcester 28CDI Combi, all works ok except that it won't deliver hot water constantly, flames stop and restarts after few seconds. What is the diagnosis please

Hi All have searched for this information without any success, could anyone inform me what the error diagnostic lights mean Please ? model is BDI631 Dishwasher 7 lights / program lights 1 & 2 solid lit, 3 & 5 flashing Thanks

Was convinced the 15 yr old cartridge needed replacing to sort our shower temp problem. But it seems the worcester 28cdi is cutting in and out, whats the cure please ? THANKS

Hi Is this acceptable ? run 240v switched supply using 2 core cable to each GU10 connected in series using ? connector terminal blocks (choc blok) because the covered round terminal units are too large to go through the downlight apertures ? thanks

Hi Charger for my Ryobi 14.4v NiCad Drill has packed in. Can i use another charger i have ? Ryobi charger output was 18v 300mA Alternative charger output is 22v 450mA 9.9va - which was also for a 18v NiCad drill plugged it in and the charge light comes on, just concerned if it may...

Hi currently have a Worcester 28cdi combi and 1 Mira balancing shower, works fine if no one else in the house uses any water. Intending to fit another shower in our loft conversion. Should i stick with another balancing type shower or go to electric type ? comments invited, thanks

Ok for my loft conversion i need to insulate under the rafters, multifoil insulation is the most space effiecient and represents 200 thk insulation. Is it still necessary to fit additional rigid insulation celotex/kingspan between the rafters first ? Can i use rockwool type ? Thanks

Hi recently the brake pedal has dropped and only works from half way not spongy pedal was thinking that maybe a brake pipe had burst jacked the vehicle up and i can rotate either rear wheels when the brake pedal is fully pressed with the engine running ! looked all around the rear...

Hi Have had this Mira 415 for 12 years fed from a Worcester Combi boiler, have not had to touch it in all those years. Has recently starting intermitanyley varying the water temperature, should i just replace the whole unit or is it just down to a worn cartridge ? Does the pressure...

Hi Having a problem with losing pressure in the system Followed the link to FAQ carried out the exp vessel repressurisation sequence A small dribble of water came out of the air connector with little pressure behind it. So i pumped up the vessel a bit and then released the air...

Hi Have had a search and good read here but cannot find the answer as yet Please comment Boiler been in for 10 years ok currently gauge reads 0.2bar when heating is on it rises to 3bar when heating is switched off it settles to the norm of 1.5bar, but after 2hours it returns back to...

Having problems with a 28 CDI combi, and would like some ideas on what is the specific solution PLEASE Central heating stops working and 'domestic hot water demand indicator - flashing fast red light. ok Manual says its Air Flow Fault (RSF) checked fan flue, looks ok sparks and...

Hi and what are the faults with them ? Having issue with 28cdi Worcester Combi

Hi Having problems with a 28 CDI combi, and would like some ideas on what is the specific solution PLEASE Central heating stops working and 'domestic hot water demand indicator - flashing fast red light. ok Manual says its Air Flow Fault (RSF) , Flue Gas Spillage (OF) what do these...

Hi DWI16 12C Tried to reset without any success When machine is switched on lights 4 and 5 on permanently and after a few seconds intermittent beep sounds continuously Is this a dreaded possible PCB problem ? Are there any checks that can confirm PCB faults ? Assume cost of...

Model DWI16 12C Control Panel error lights 4 and 5 on, what does this error mean ? Have tried to reset the machine the normal way, it does not reset What can i do ?

Is it possible to router a slot in the door and fit intumescent seal section ? Would Bluiding Control accept ?

Hi currently have a shower running from combi boiler, has the usual problem of temp change if any other householder flushs toilet etc. But i wish to fit another shower in the new loft conversion, would it be better to install an electric shower or would this still be affected by water flow...