Search results

  1. M

    LED Mirror

    Hi - anyone know of a mirror - ideally 600 wide by 800 high with the shaver point and IR sensor (or switch) on the LEFT? The one supplied and all others I can find on line have these on the right and there isn't room between the unit and the wall to plug a razor in of for the sensor to work...
  2. M

    Extractor fan selection

    Hi - I'm installing the ducting for a holiday let with extractors in the two en-suite shower/wet rooms, a kitchen and a shower attached to a sauna. I've sized them all and am looking at in line duct fans for the two shower/wet rooms of about 240m3/hr and about 25dBa at 3m. This is over spec...
  3. M

    MSF100 Switch fuses and amended regs

    I need to install a second switch fuse for a separate supply to an extension. Would prefer to use this model as they are small enough to fit onto existing board in a small cupboard where the supply enters the house (and leave room for the extra RCD that's now required) but concerned that they...
  4. M

    Wago connectors

    Anyone had experience with these or similar makes? Look useful especially for lighting circuits?
  5. M

    Extending cables to move a consumer unit

    Hi - doing a small job which involves extending cables to move a consumer unit. Always used connectors to do this before but advised recently I should use crimped connectors. Any thoughts?
  6. M

    Vynckier CU

    Hi - a customer has a Vynckier CU and I need to add an RCBO for a cooker circuit. I can't find this make in any catalogue - do you know if other makes fit? Andy
  7. M

    Porous block walls

    Hi - I've just completed 250 feet of 9 foot high 9 inch re-inforced block walls around a farm building and now find that they get wet on the inside when the rain drives against them. They are filled with concrete. Does anyone know of a good product with which to seal the outside? Andy
  8. M

    Lighting for barn

    I'm trying to get some advice on the most efficient lighting to install in a 4 bay agricultural barn - each bay is 20 by 36 feet and 15 feet to the eaves. The building is new and I want to do the best I can to install low energy fittings. The advice I've had so far is to use 'low pressure...
  9. M

    SWA Cable sizing

    Why is it that a supplier on this site states that 4mm SWA cable has a current carrying capacity of 45 amps whereas my local electrician now tells me it needs to be at least 10mm if not 16mm? The run is 100m and we need a 32 amp supply to run a small welder - otherwise it's only for lights...
Back
Top