Search results

Just had a 15l Ariston water heater fitted and it is constantly dripping through the Tundish. On the pipework from the mains is a Pressure reducing valve, Then they have put the pressure relief valve to a tundish, then the expansion vessel, then into heater. Have they done the pipework...

I have a Indesit IWDC6125 washer/dryer and its just stopped working. There is no power on the display panel at all and nothing works, no lights. I have checked the wall socket and 13 amp fuse and both are ok. Would the door switch cause nothing to come on? Does the model have a fuse inside...

I rent out a little flat which suffers from condensation every winter. I have educated the tenants to try and prevent mould but still have problems! I am thinking of fitting 2 permavent x1 in the kitchen and x1 in the livingroom but feel they are very expensins for what the are which is x2...

Hi my teenagers shower until the hot water runs out and no matter how many times I nag them they continue to do it! I was thinking of putting a Time lag switch on the wall in the airing cupboard so they would need to press it before getting in the shower and it would last 15 mins and then...

I have a airing cupboard in the bathroom and was wondering if it is OK to put the fan isolator switch (not a pull cord) in their rather than outside?

I have an old basic extractor fan in my bathroom which I would like to replace with a timer fan that needs a switched live feed. The problem I have is that the current wiring is just 3 core L N E. Would this set up work (see below) if I just took the single switched live wire from the ceiling...

Is there a way to remove dents from my aluminium Roller garage door slats? Click below to see door............. https://lh3.googleusercontent.com/-U9KfJe6emqE/U7ATSrc3O9I/AAAAAAAAAXs/dNxM6vMnwkc/w793-h595-no/Dents.jpg

I am taking up my old wooden flooring and laying a new engineered floor of the same 14mm thicknes. The floor is in the Hallway, Lounge and Dining rooms. Is it OK to have a continuous flow or do I need to stop at the doorways and put strips between the rooms under the doors as there...

I have a Yale Composite back door and I would like to fit a Cat flap in it. I am very good at DIY and would rather do this job myself as I have fitted one before in a wooden door. Make a template of catflap, make sure its level and draw round it, drill holes in the 4 corners, cut out using...

What is the best way to fix this problem? Above my 1st floor far left window lintel there are 6 courses of bricks that are loose below the arch (See photo) when I push it with my hand the whole lot moves in and out as one about 1cm! Or see this link:-...

Hi My sons LG32LC2D TV has been crackling from the speakers and now he has lost all freeview channels and it will not retune. Although the tv turns on and the screen say "no signal" He is unable to get any picture at all not even through his XBox! Any idea what this could be and do you...

I have a Candy Fridge Freezer Model CPCA291FFK and the upper Fridge compartment is acting like a Freezer although the thermostat is turned down as far as it will go! The Freezer compartment below is working fine. I have had an Engineer look at it and he has said it needs a new PCB P/N...

I have a Double gargage and had a Insulated Aluminium roller door fitted 3 years ago and is now very badly corroded and causing the paint to flake off everywhere. It was only guaranteed for 2 years so cant do anything about the warranty so I am going to have to replace the slats/curtain...

I have a Double gargage and had a Insulated Aluminium roller door fitted 3 years ago and is now very badly corroded and causing the paint to flake off everywhere. It was only guaranteed for 2 years so cant do anything about the warranty so I am going to have to replace the slats/curtain. I...

Hi I have a Dimplex XLS24N Storage heater and it has stopped working. The other storage heater in the flat is working fine. Could it be the Thermal Cut Out as my tenant did have a sofa up against it? If so how is it reset and what am I looking for once I have removed the front cover...

I had installed a double roller garage door made from insulated aluminiun slats about 5 years ago and because I live 100m from the sea we get a lot of salt spray in rough weather. The slats have now corroded very badly, so I need to replace them but am looking for something that wont rust or...

My boiler is Ketling and I would like to add some Sentinel Rapid Dose X200 Descaler as I have heard that its quite good. Does anyone know how many radiators does Sentinel Rapid Dose X200 Descaler 400ml treat? I have 18 rads Thanks

I think my Potterton Suprima 60L Boiler flame is to high. The boiler is noisier than usual, the flame is a bit yellow and the cabinet gets very hot to touch. Its heating tha Rads and water fine though! All the rads have been properly bled but it did not make any difference. What could...

Still cant find a Multi Region Hack using the original remote! I Know it can be done using a "OneForAll" so it looks like I will have to buy one of those which cost just as much as the player! Once I have done the hack with a "OneForAll" can I go back to using the original remote that came...

I have just fitted a NEW side entry valve that came with my new cistern, it fills up nice and quite until it gets to when its going to shut the valve off, thats when it starts to Judder and make a lot of noise. I have tried turning down the water pressure but it made no difference. I cant...