Search results

  1. B

    Bathroom Fan Heater

    I am proposing to install a down flow fan heater above the door of my Bathroom ,to replace an existing radiant heater. It will be in Zone2, so I need an IPX4 rated unit. There seem to be only Dimplex and Creda models suitable. There is 227 cm from floor to ceiling and only 28 cm above the...
  2. B

    RCB v.s. Main fuse rating.

    My incoming supply fuse has been uprated to 100A. As well as one CU with a 100A RCD, there is also two separate 63A RCDs each with their own fused switch for outside services. These RCDs are connected in parallel with the CU, directly to the output side of the meter. Is their rating OK, given...
  3. B

    Heating- Reversal of 3-way valve.

    I have a y-plan combined HW/CH open vent conventional system. There are other separate systems for HW e.g.Rayburn and Solar. Consequently the 3-port valve is almost always programmed in the CH position and is permanently energised. Can the valve be plumbed the other way round so the CH port is...
  4. B

    Vibrating TRVs

    I would welcome any suggestions for the following problem. I have recently replaced some radiators and fitted Drayton TRV4 valves. All ground floor rads are on inverted loops i.e.the pipes run around at 1st. floor level and drop down to each downstairs rad. The system is 10mm microbore. On...
  5. B

    Miele electronic freezer

    I have an f7131 s freezer which is too cold.It is not switching off so the temperature is down to the maximum indicated of -32 c.I guess it does not have a conventional thermostat. Does anyone have any advice and how do I get into the electronics? we have done all the obvious things e.g...
  6. B

    Miele W828

    I have a Miele W828 washing machine which has been a workhorse for 7 years but has now failed. It takes in water, agitates and then immediately pumps out. The 'rinses' light flashes continuously and the 'anti-crease/finish' light comes on. This pattern occurs on all wash and rinse...
Back
Top