Highly likely you have a heating issue....open circuit heater element, break or bad connection in heater wiring, defective heater relay on pcb, or NTC failure. Check element resistance with a multimeter first ( should be 25 - 30 ohms).
Thanks -But as it is a machine with both hot and cold water connections could it still be a heater element ? I had a look inside and found an unconnected yellow/green wire seemingly attached to the motor as the spade terminal had fallen apart. Have reattached with a new spade terminal and waiting to try machine again later today.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local