cutting 2X6 board

Joined
6 Feb 2007
Messages
1
Reaction score
0
Country
United Kingdom
What is the tool used with a table saw to get the correct angle to cut from corner to corner? Wanting to get a 75 inch angled length board.
 
Sponsored Links
Sounds like the OP wants to cut furings, don't think a mitre guide will do that :rolleyes:

You can make a taper cutting attachment that is often used for table legs but at ocer 6ft long it will be too dangerous. Use a straight edge to mark corner to corner then feed it buy eye.

Or tack a 7" wide strip of ply to your 6x2 with one edge aligned corner to corner, set your saw rip fence to 7" and feed the ply/timber through the saw with the ply against the fence, this method will give a straighter cut.

Jason
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top