Gas hob Belling

[mmcostex]

There is a rotary nut type fitting on the hob piping but there is nothing for this to screw onto. Should there be an elbow type fitting with a female thread and washer in the box. I want to connect onto 10mm copper. Please advise .

Thanks Mike

 

[doyle]

could be wrong as ive not done hobs yet, but i would presume that the pipe is gas tight compression fiited to it, have you looked for a reducer fitting for it(compession to end feed type). best option would be to ring technical services listed on the mfr instructions to ensure what you are doing is correct.

 

[Lagerkhan]

Try one of these
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100122&ts=79320&id=23297

Plus one of these
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100122&ts=79366&id=14890

OR this
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100122&ts=79540&id=17647

And don't forget this
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100576&ts=79636&id=17373

 

[gas4you]

You normally get a 90 fitting to come off the hob inlet so it points downwards for ease of fitting included in the hob kit

 

[mmcostex]

You normally get a 90 fitting to come off the hob inlet so it points downwards for ease of fitting included in the hob kit