- Joined
- 28 Nov 2004
- Messages
- 368
- Reaction score
- 58
- Country
Many moons ago, I plumbed in the hot water side of my Potty Lynx 2 to supply the usual bath, basin and kitchen sink. Although the kitchen sink is virtually opposite the boiler, the h/w pipe was run around 3 sides of the room (in 22mm) to reach it.
Quite a wasteful dead leg to say the least!
Therefore I am plucking up courage to do the obvious and run the kitchen sink h/w pipe across the room in 15mm (chased into the concrete floor) and then relay the bath and basin supply also in 15mm.
Worth the hassle?
A good idea?
Any extra advice?
Thanks to all, even if you just take the P!
Quite a wasteful dead leg to say the least!
Therefore I am plucking up courage to do the obvious and run the kitchen sink h/w pipe across the room in 15mm (chased into the concrete floor) and then relay the bath and basin supply also in 15mm.
Worth the hassle?
A good idea?
Any extra advice?
Thanks to all, even if you just take the P!
