Hotpoint Aquaris WF320

[Richs1984]

Forgive me if this has already been posted but I new to the site and not sure what to do!

I have a Hotpoint WF320 and from what I can gather from fault lights the pressure switch isn't sensing.

Can anyone advise what I need to do?

I have looked a little online and they suggest that it could the pcb or even something trapped inside machine?
I'm at a bit of a loss with it all and desperate to get it sorted ASAP

Any help would be greatly appreciated

Rich

 

[rocks1]

Check the filter / blow down the Presure pipe.

 

[Richs1984]

We brought the machine on gumtree when we were skint and there doesn't seem to be a filter (!) I'll give that a try and let u know, thanks for the advice

 

[Richs1984]

Took the pressure switch off, blew down pipe. Checked connections and even blew into switch and it still 'clicks'

Still not going. The cycle will start then stop and fault lights start going

 

[rocks1]

What lights are flashing. Ingnore on / off

 

[Richs1984]

Wash enhance
Rinse hold

 

[rocks1]

Thats error f10 , it's one of two. Presure switch or pcb. Switch costs a tenner pcb 80.00.

 

[Richs1984]

That's what I was afraid of, pressure switch is fine . I only paid 80 for the machine!