Indesit W123

Perplexed171070 · 22 Nov 2006

Hi! We have an Indesit W123, but it's all over the place. For a while, it would start a program, but then the dial would click round endlessly, and the program needed to be stopped manually. Now, when you start a program, the drum fills up with water, revolves a bit, then alternately pumps out and fills up again. The dial doesn't move around at all. It can be switched off and moved on to a spin cycle, but then when the cycle completes it starts filling and pumping again until switched off.

Any ideas?

Anthonyl · 22 Nov 2006

put it on the dot at the end of the each section and it should cancel the cycle with a few flashes of the led on facia, if that does not work it sounds like pcb.

hope it helps
Ant
____________________________
Lynda, moderator

Please note forum rule 7

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Indesit W123

Perplexed171070

Anthonyl

DIYnot Local

Similar threads