Hope you can help. I've got a Potterton Lynx 2 combi boiler. Just had it serviced and was told it was in reasonable condition. Last week it lost pressure so I refilled it to 2.5 Bar ( loses pressure about once every 6 months ). This caused minor leakage for a while but it has now settled at 2Bar and was working fine. However. got up today and the water will not heat. The LEDs for Water Heating, Ignition and Demand all come on and I can see the ignition spark working okay. However the gas is not igniting and so after a few seconds I get a reset message. Any ideas? Would lowering the pressure help at all?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Potterton Lynx 2 no hot water
- Thread starter andy_h
- Start date
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
