Dishwasher model: DWI 710E1
The dishwasher is repeatedly stopping shortly after starting the cycle The lights indicate a 'E2' fault - safety pressostat intervention.
According to the manual, the defect can be caused by:
- defective pressostat level
- difficulty to connect the pump or faulty washing pump
- water in the safety pressostat pipe
- filling solenoid valve with high flow rate
- electronic card which does not read the 'full' signal
To be honest I don't know what any of those mean. Which of them are more likely to be the cause and how do I go about checking/fixing?
Thanks in advance.
The dishwasher is repeatedly stopping shortly after starting the cycle The lights indicate a 'E2' fault - safety pressostat intervention.
According to the manual, the defect can be caused by:
- defective pressostat level
- difficulty to connect the pump or faulty washing pump
- water in the safety pressostat pipe
- filling solenoid valve with high flow rate
- electronic card which does not read the 'full' signal
To be honest I don't know what any of those mean. Which of them are more likely to be the cause and how do I go about checking/fixing?
Thanks in advance.
