Recent content by ANDYSI

  1. A

    tricity bendix spin problem

    I have recently removed the belt and the motor runs fine and the spin program completes its full cycle but when I replaced the belt the same problem appeared, incomplete spin cycle. I am assuming that there is a problem with the motor. If so I would prefer to buy a new machine as machine is...
  2. A

    tricity bendix spin problem

    Tricity bendix aw110w machine goes through full cycle but when it gets to spin cycle it spins for a few seconds and then stops and the timer goes through to end of cycle. Any advice would be appreciated. Andy
  3. A

    biasi 24 S boiler 'not gettting any hot water' Advice needed

    I had exactly the same problem, I had 4 engineers look at it they changed 3 way diverter valve twice and replace diagphram, but still same problem. I decided to turn the water pressure up slightly at mains stop cock. I haven't failed to get hot water since. I think there wasn't enough pressure...
  4. A

    bIASI 24 S 90E PRESSURE DROP

    I have a problem with biasi 24s 90e combi boiler which is dropping dropping filling pressure (aproxx 1.8 bar to 1.2 bar in a couple of weeks), but the the heated pressure is remaining constant approx (2.2 bar at 55 degrees) when heating is running. Is this more likely to be a leak or a...
See more
Back
Top