No afraid not it seems strange that i can buy a double insulated pull cord dimmable bathroom pull cord switch that i can't fit into my bathroom?
Being desperate now am i allowed to simply replace the pull cord switch that is existing with the new one, (had the door rehung so it would now be...
My bathroom is 310 by 190 looking at your diagram it would appear that i cannot fit the switch in the room because the shower cubicle is on the left as you enter the room with the bath being the other end, i don't want to hang it in the hallway?
I am fitting a new grohe monobloc to my bathroom sink it has chrome 10mm pipes for hot and cold, trouble is i can only find flexible tap connectors that have 15mm compression one end and 10mm screwed the other to go into the monobloc itself, what i could really do with is 15mm to 10mm pushfit or...
sorry for the confusion i did leave a comment but then realised that my machine had a slightly different number i couldn't remove so deleted my comments, didn't mean to upset anyone.
What i actually said was that my machine had the same symptoms and it was the door interlock that was faulty...
I must admit i thought everyone was charged the same fee but judging by the posts they are not i have just had my car MOT'd (tuesday) and it cost me £45
ChrisR sorry away yesterday, if i turn the hot water tap on but turn it off before the burner has actually fired up the pump runs for 4 minutes on the overun, so i don't see how the water can be hot when the boiler hasn't had the chance to heat any water i give this as an example if i run the...
As an update on this problem, a worcester bosch engineer has again looked at the boiler and deduced that there were two faults, firstly on the gas valve there is a maximum and minimum adjustment, the minimum was not calibrated at all so it was not able to modulate the burner according to heat...
Thanks for the many replies, don't think it is a problem with the shower mixer as all of the hot taps produce water that is far to hot which triggers the burner to shut off temporarily making the water run cold before reigniting.
The heating side of the system is working normally.
Can...
Ok understood thankyou all for your informed help, thank hevens for the internet hopefully when the tech guy gets to see the boiler i am forwarned as to what to expect.
As a footnote should the engineer have spotted this or is there an excuse to be made you know " sometimes can't see the wood...