Recent content by Bods

Leccy, thanks for your help, it's been invaluable (i also noticed how many other replies you made on the forum in general, you provide a great service). I will look into your suggestions tonight. I have also seen suggestions on other threads regarding load balancing sensor / pressure valve...

Leccy, Thanks for the responses, they're much appreciated! The situation now is, i have taken off the motor and the brushes seem fine (they've got about an inch or so left, i'm assuming this is ok), so i am now stumped. I've noticed that the suspension arms supporting the drum are starting...

Thanks for the Reply, Leccy! Is it common for worn brushes to just affect the spin cycle? Would they not stop the drum turning altogether? Thanks Again

Hi, Our Hoover washing has recently decided not to spin, at all. It washes fine, goes through the rinse programmes ok, but when it reaches either spin programme, slow or fast, it spins a couple of times slowly (i assume to balance the load) and then stops. The pump can be heard...