Recent content by BoiledUP

Calcium = 65.7250 Magnesium = 20.1538 According to a home brew forum - the ppm can be worked out using these two figures. BUT. Half asleep and mathematical conundrums don't do it for me..lol. I will try to figure it out tomorrow. Thank you all. :D

Ha ha! Ignore that last post - half asleep..lol.

pH (Hydrogen Ion Conc.) = 7.65 Does that look about right? Not sure I got the right thing but looked like it. :D We didn't have any kind of de-scaler on the old boiler..so maybe it's not too bad round here?

Oh..sorry everyone that's replied further. Didn't realise there were more replies. Thank you muchly. I checked the water here and it's moderately hard at 90.6mg/l. The Intergas engineer says he will wash my radiator system through twice before installing the boiler so hopefully that should...

Thank you doitall, I will keep my eyes peeled. :)

Just checked for prices on those and they are £100+ this is the problem. We have no money left to buy one. So, we don't have a choice really. Thank you for the information though - much appreciated.

No worries - have spoken to Intergas and they have advised. Thank you anyway. :)

Hi All :D Finally I've sorted out finances and am having an Intergas boiler fitted next week. I was recommended to have a Magnaclean installed at the same time as the boiler, but can't afford it unfortunately. Would anyone be good enough to advise me if this or anything else (ie limescale...

Thanks so much Matt, Thanks for the ideas of what it could be. I can at least have an idea what any new engineer should be looking for if I can get someone out. Don't fancy Crimbo without water or heat! Santa's definitely not gonna want to visit if it's colder in here than outside lol. :D...

I know Dan, I'm not a loony fortunately. :D A bit blonde at times, but even in the face of adversity and knowing that my previous guy has probably ended up costing me a lot of money, I'm still sitting here smiling and hoping I can get this sorted out. :) Have been through far too much...

We don't have a room stat. I honestly struggle to believe that someone would refuse to look at it due to somebody else's incompetence? The guy I used isn't just someone I dragged in off the street - he has a business and is registered - how is a member of the public supposed to know if...

Hey Guys - thank you. I'll try to answer as many questions as I can. 1. The fuse blew when he got his mate to turn the electric back on. 2. He cut the cable because he thought there might have been a problem with the supply to the boiler so wanted to bypass the original supply, put a plug...

New thinkings! 8) I've now been told that as we have 15mm piping to the old boiler, we would also have to change the gas supply pipe to 28" to install a condenser boiler. Just don't think we can generate enough cash to do all this. :( So... Been hunting down parts for the old boiler that...

Hi Agile & Mat1e, To be fair the guy I asked to look at it is supposed to be registered and whom I used for servicing the boiler. He cut the mains wire to the boiler in half (which cut power to the whole house) as he thought this was not live - due to the fact that he thought he'd already...

Hi again, Just had someone out to look at the boiler and he thinks that: 1. The PCB board has blown as it smells of burning everytime the power is switched on. 2. The fan may have broken. 3. There could be more faults as the wiring seems to be all wrong. 4. It's going to cost a lot of...