i took it off as it seemed to be not working correctly
i undone the compression fittings and took out the valve itself to make sure it was running freely and put it back and took that photo i manually turned the spigot part to midway as it is in the photo but still no hot water. the head is...
i put it in the mid position. i took off the head as i didnt think it was working and that it might be stuck. ihav had that whole 3 port valve apart and does turn freely
thanks
no i havent so no idea why this has happened. success on the heatingh but still no hot water pump is running ok when the cylinder stat is turned from 0 degrees to 70 i can here the pump kick in but cylinder does not heat up. it heats when i use the immersion side.
any ideas gratefully...
i have chased the hot rads to the last one and turned them off got them all going do i swith off at the trv or do i need to turn off the lockshield too? if i do start to get hot water in the cylinder what shall i do next. am off up to check the hotiness off the pump :)
thanks again
the pump seems to be spinning freely but it is hot. am gradually getting 2 rads hot then switching them off till the next 2 heat but still no hot water?
thanks for the help
oooo thanks for the thought of a rodent corpse mmmm. i took the tank out and gave it a thorough clean and all back in. only thing is i have only 2 rads working and no hot water. i have taken the motor part of the 3 port valve off and turned it so that both should be on. but to no avail. does it...
right Friday's update
drained down the system that wouldnt fill yesterday at all but did overnight. got my trusty hacksaw and suddenly remembered what Pete had said just in time which was to block the tank, i had found a baby bath in the loft and brought the flexi hose from my henry hoover up...