Recent content by c9550927

Hey folks, Bit of a puzzler this... installed a Veritas R8 a while ago and it all works very well on all eight zones. Odd thing I found is that if I set the panel on High Level Chime (chime at full volume) the RKP makes no sound on door opening. If however i put the volume back to "normal"...

thanks everyone :mrgreen:

sorry for the confused post. I have 1 sounder. What I dont understand is what position the jumper JP2 (marked SAB) should be in. At the moment its in factory default (bottom two pins). The battery and LC (low power) are clearly marked which pins are "ON" but there is nothing for the middle...

Right external Sounder box ... has 3 x 3 pin jumpers to configure, marked as follows. [code:1] ON ON . . | . | | JP1 JP2 JP3 [/code:1] JP1 = Battery (ON/shorted) JP2 = SAB (bottom two contacts shorted) JP3 = LP (lower...

Just wanted to update, T0058 fitted, leak gone and diaphragm (+ washers and piston type bits) replaced... result. :D

when you open the taps that feed into the p-trap,how fast does the water flow?. I'd suggest there is a blockage, possible due to build up of food stuff/grease. Have you tried caustic soda crystals left down sink to dissolve the gunk?. The other option is to use a pipe cleaner. I've seen...

i'd suggest you install a stop cock inside the house for the hot water in case some bright spark thinks its funny to leave your hot water running overnight.. or when you go on holiday

Sorry should have said, i had a complete loss of water in CH a while back (house was empty as I was working away from home, but checked all rads and they are dry), couldn't figure it out, topped it up and its been losing water steadily ever since. I believe this constant dripping from the screw...

not the same boiler but just throwing it out there, i had the same issue with a Vailliant, it was the diaphragm in the diverter value that was gone. When you request hot water, check the pipes (touch them); see if right pipe (under boiler) is getting warm.

if you get really desperate i think B&Q do some too (bit expensive vs screwfix or your local merchant)

No worries, really appreciate the help and advice.

screwfix sell LOADS of bungs, tried them?

Big thank you to you and 45yearsagasman... got enough info i think to give this a bash tomorrow :-)

here is the relevant page... cant see 0176 ?. did you mean 0716 ?. The kit is T0058 but the 0870 seal is only a couple of quid (not in the kit) so a simple/cheap buy

Which is odd for two reasons, 1) That there would only be 1 screw used in this section (see my pic), another user on here has posted that they only have 1 screw fitted 2) that the water would be leaking from the bottom screw hole, have seen this myself and then saw it leak from another...