Recent content by cakeman

ok great have orded another http://www.casaparts.co.uk/products/id-19071020

checked that , the water is just slowly trickling through the upper spray arm

I have an issue with this Siemens Dishwasher SE25M275GB/36 Upper Spray Arm not turning . Everything is working except for this. Spray arms are clean and no blockages , manifold clear too Motor was siezed but i unsiezed it and now it works fine . any ideas ???

the dryer manifold is on the top . check the wires there is usually the temp limiter as a place to start

does the water get hot ?

motor possibly siezed either free it or get another what is the model number

hi Phil It is part of the assembly but some places sell separate http://www.casaparts.co.uk/products/id-04100910

it did :D

possibly a motor failure or a leak from the motor have a look underneath at this part http://www.casaparts.co.uk/products/id-15041006

Hi I have come across a confusing intermittent problem on the machine mentioned in the title switch the dishwasher on and it Drains Fills the motor starts , then it just stops, leaving inlet and otlet light flashing checked the motor it works fine and no debris inside the housing the...

sometimes can be bits of paper and plastic blocking the motor impelloer rotors. Take off the outer casing to reveal the impellor and clean out the little lugs caustic soda - sounds very entertaining :evil: :shock:

Dishwasher always a cold feed only

:roll: driller thriller 8)

its a case of go for it - nothing to lose :shock: :shock: :shock: :shock: :shock: :shock:

heat will do it blow torch on the bearing hammer it with a screw driver from the opposite side it will shift - battle of wills