Recent content by Carl Tales

Just to add Picasso was on the money with his first reply

Yes sorry I should have posted. My fault is fixed. The issue was the valve which had a dodgy cable. If I wiggled the cable it would work. I replaced the valve which fixed the problem

Hiya. Yes sorry I should have posted. My fault was with the valve. Although the valve was working intermittently the cable in to the valve was breaking contact. I replaced the valve and all is now working.

Thank you

I just tried my system and for the first time I noticed one or could have been both red lights turn on but immediately turned off. Green lights remained on.

The fuse underneath the orange is ok yep.

Hi again. I tested the voltage on the orange and it does get 240v when calling for heat. No voltage on the pump terminals.

Thank you. I’ll check the voltage

Ah sorry yes the electronic valve is working fine. When I call for heat I hear it open. And closes when I turn thermostat down. I do get hot water through this valve to the manifold when my other manifold is on. It’s just the pump isn’t pumping it round and my flow meters remain up.

Thanks. I don’t have multimeter but have just ordered one from Amazon. I’ll check thanks

Here you go..... Thank you

Please can anyone offer advice on what may be causing my boiler and pump not to kick in when my UFH zone is switched on. I have 2 separate manifolds. One works snd the other doesn’t. The one that doesn’t has power snd the actuators switch on and electric valve opens but the pump and boiler...