Had a look at the PCB for dry joints and the problem has got worse. The ignition doesn't work at all now.
I have ordered and new PCB and let a professional fit it.
Hope it works.
I have a Glow worm micro which is 4 years old. It fires up and works fine for a while and then the burner light goes out but the pump/fan inside continues. I have to turn the boiler off/on using the control knob on the boiler a few times until the burner light comes on again. Once again it works...
Last night I just left the Heating on and the boiler worked fine. The thermostat did it's job and when needed the boiler fired up.
The problem must be on the Hot water side of things. Does anyone have any suggestions why the boiler cuts out when heating the water.
I have traced the problem back to the Glow Worm Micro Boiler. Once it fires up everything is fine but when the Thermostat cuts in the boiler doesn't fire up again when it should do. It goes through the motions and clicks a few times but it doesn't always fire up. I have to manually press the...
I have a Glow worm boiler and hot water tank. When I turn on the Hot water and Heating both Actuators switch to 'B' but the pipes either side of the actuators do not always heat up. I have to switch everything off at the timer and turn the Hot water on first, when the pipe starts to get warm I...
Thanks for all the advice.
Well I bought myself a Solder iron and fixed it myself. The finished job looks just like all the other 'Proffessional' joints and the boiler is no longer sparking. Just glad I didn't buy a new PCB when it wasn't needed. It was such a simple job in the end and I'm...
Thanks for the answer I will swap my board for a refurbished board tomorrow and give it a go. After searching the web the dry joint seems to be a real problem with this PCB
I am dying to try the DIY solder option but haven't got the tools or know how.
Thanks
My boiler keeps losing all power this happens about once a month. The circuit board seems to be shorting out and when I move it the lights come back on and the boiler works fine. I want to replace this circuit board and the number on it is 21/18887.
Do you think this will solve the problem...