Recent content by col999

Ha! I'm married to a liverpudlian but living in the west country; now that is interesting! My original question about the gas was because my wife is not keen on me messing with gas :P If I could remove, clean and replace governor (after I have now tried flow rate!) without touching gas...

See, I told you I was just learning plumbing :) It is the Brittony II and now you mention the two dials on the front I know exactly what you are talking about. When I get home I will reduce the flow and see what happens. Funnily enough, I have noticed that the flow rate increased at about...

Thanks for that. Is the water throttle something easy to recognise and turn down? I least I can check that out. However the water tends to run colder then heats up for a couple of minutes then runs colder again. Also I have never noticed a drop in water temperature when the outside temp...

I have a Brittony water heater. The water from it has started to run a lot colder than before but everything 'appears' to be working properly. The manual says that the water governor could be sticking and therefore remove, clean and replace (all of the other options in manual I have...