Recent content by cometguy

just a little note to anyone else with the same problem. t.o.c's (thermal cutouts) can be of different types (not only temperature), usually there are 2 - one is a self reseting and the other is what is called a one shot. it is normally the one shot that goes. the differnt types include a...

im a service guy from comet! note hotpoint/indesit/creda dryers are all ****!!!!!!!!. the belt does not go for no reason, there are a few reasons common to these dryers. listed as most common is the following. 1) back bearing goes (check this first.). 2) jockey wheel (bolted to the motor). 3)...

there is a blockage in the pump float chamber!!!!!! this needs addressing now as condensation will be building up on the heater and will eventually start tripping the electrics. what u need to do if the following. 1) remove the lid then the side panel on the left(if youre looking at the front(4...

dishwashers fine, however a washer would require a gap between the washer and cabinet (minimum 10mm) to avoid vibration tranfer durin spin cycles. other than that its fine.

the motorised selector switch will turn round to indicate a fault. common on this model is a motor fault or open cicuit heater! however if u've removed coins its possible that the pump may have blown, damaging the module.

there are a few dishwashers that use a half load function (not important). there is only one pump that provides water to both spray arms, and pressure to both should be the same. how do u know that they are not opperating correctly? the main cause of spray arm problems resides in the last...

be careful, washer paint is not enamel & some petroleum based products can damage both plastics and paintwork (id use petrol lighter fuel) and yes i know it sound contradictory, but this does work with sticky labels etc without causing damage.

i've been a white goods field engineer for comet for a few years now! anyone know where i could obtain indesits wash doc program? i've already obtained a mark2 & 3 test plug and serial lead to connect them to my laptop, also evo 1 & evo 2 blank eproms. it would be handy to programme eeproms...