Recent content by conroyster

Just fitted the relay and we have power. Thanks for all your help rocks1, it was much appreciated. Just for completeness, I did manage to remove the dial and the screws behind it. As rocks1 stated the dial just pulls off. Good tip I found on the internet for that is to put an old towel/cloth...

Hi, I have a creda t622cw dryer which does not stop when the door is opened, only when the dial is turned to 0. Any advice is greatly appreciated.

Again thanks for the response, it is much appreciated. How do I access the consol/control panel? As I mentioned previously, I have removed the top panel (via the back screws) and then removed 4 screws (one screw in each of the corners), which I thought would allow me to remove the consol...

Hi rocks1, Thanks for the reply. The reason I suspected the switch was that it no longer making the clicking sound when it is pressed. Assuming it is the relay, how easy is it to replace, and can anyone give me a link of where I can source the replacement part. As always, any help...

Hi, I have a creda t622cw dryer, were the start button does not hold it's position, hence it cannot be turned on. My plan was to swap the connectors between the on/off switch and the low/high heat button (as this is working) to test whether the it is just a case of replacing the switch...

Hi, we have an Valliant Ecomax Boiler, which seemed to be working perfectly, then I discovered the plastic overflow pipe was leaking were it was connected to the boiler. When I checked the boiler's display screens, the pressure gauge read 3 bar (the heating was on at the time). I switch the...

Again, thanks for the advice. I will be upgrading the cable myself, but I do have a couple of questions that I am hoping people will help me with: - is the follow cable be of good enough quality...

Cheers for the information. Regarding the link to the cable, where does it state that it is WF100? Excuse my ignorance. For HD, I was under the impression, from other posts on this forum, that you could split and amplify the hdmi connection and distribute, with specialise equipment, the...

Thanks for the suggestions. I have altered the RF Channel, but that no joy, picture quality problems persist. Here is a break down of the picture quality (PQ) for each of the TV's: Living Room (with Sky Box): - Sky channels (via SCART): excellent PQ - Analogue channels: awful PQ -...

I have just redone the connections, but it has not made a difference. There is a deterioration the further away for the amp the tv is. Am I right in thinking this could be caused by a poor signal going to the amp? We have had some bad weather over the last month and picture quality on the...

Hi, Thanks for the replies. I will check the connections, thank you all for the advice and information. I was however under the impression that length of the cable will effect signal quality, the furthest length is between 15m-20m away for the amp. PS. I have fixed the error to the link...

Hi, I currently have a sky+ subscription down stairs in the living room. The aerial from the roof goes to the sky box, and the RF 1 and a scart connection go to the tv in the living room. I purchased a distribution kit http://www.maplin.co.uk/Module.aspx?ModuleNo=223487 and have a cable...

Hi, I am doing some work in the loft, which currently has 2 lights controlled by a single switch. I wish to add another light and switch to system, were the new switch will only control the new light. The new light will never be used independently from the existing lights (the new light...

Thanks for the reply. Apologies if I am a little vague, but I don't have ready access to the setup, therefore I cannot elaborate on it further. As mentioned previously, what struck me was that the switch in the hall has a single red wire and a single black wire, which, from my limited...

From my initial description what makes you think that the neutral is borrowed? Thanks