Recent content by cuboid

Got lots of cleaning stuff for carpets, limescale etc etc. Three years of stuff thrown in cupboard. If I have two of the same stuff do in just pour down a drain then rinse and recycle? Tons of rags too

Is that an engine for the pole saw?

I have this standoff - the microlite. Lots of window cleaners put it on the roof when cleaning the gutters. They don't tie it in though. Do u tie it in to roof baton? Any photos of your ladder with standoff tied in would be appreciated for purpose of roof access

Think the tie not being good was established awhile ago, a constructive comment would be how to do it. Thxs for pointing out ladder against Tower mistake as others have, won't be doing that again . What's wrong with other ladder? A bit of paint doesn't make a trade Titan Classic ladder a bad...

Which knots would you recommend tying to stile and anchor?

Do u mean the tower or the anchor in wall? Surely the higher the better. Found this pix with rope tied around stile. I guess wrap rope around both stile and anchor so no movement. Thxs https://www.ccohs.ca/oshanswers/safety_haz/ladders/securing.html

Yes.

did look into an hss course I guess similar to pasma

Just checking my tying a ladder is OK. I found that in both cases the top slides a bit left to right. One is on a wall going onto roof and one on a tower

Used this masking tape but still get bits coming through and it's not a straight line. What am I doing wrong? The line I am trying to cut in is in a groove. Anyway to improve what I've already done?

That's what I think. But some people don't even like you walking on their grass

Put this thing on at bottom or do u mean tie to the wall?

Both mine. I guess put sander on it is all I could do. Thxs

I personally wouldn't care and I didn't put a dust sheet up on them as I thought it might make surface slippier r but people are different. Some people get offended I guess. Should I sand it out and put a sheet over for rest of work? Using them at too of tower