Recent content by cwm

cheers mate, was going to do 2 :roll:

put shed roof up(8m x 6m flat) using 1/2'' OSB boards,problem being it has rain for 2 days since i did it and i havent been able to get the roofing felt on. 1 - about how long have i got before the boards are soaked and have to be replaced. or 2 - would it be ok to felt over the wet...

done a scale of 1:50 for building plans as per instructions. next to do is site plan at scale of 1:500 or 1:200 of existing and proposed,this being garden,house,boundry and any other out buildings,then adding new shed on proposed sheet? and lastly a copy of OS map location plan? these...

i have produced a scale drawing (1:50) of my proposed timber frame shed/workshop to apply for planning permission.(font/rear/side x2 and plan) as this is a scale drawing do i need to include the actual measurements on the plan/elevations etc.........?

thanks for the quick replys, my idea was to t&g exterior,to make it water tight, then board internally at a later date, after adding insulation. but inbetween adding internal boards it would be worth my time putting in some diagonal stiffeners?

i am in the process of making my workshop,8mx6mx4m to pitch of roof. when on the roof putting up osb roof boards and felt shingles the structure wobbles slightly when walking around the roof. at present there are no sides on workshop,so when i have put the sides on(t&g),will this eliminate...

will that cover 62m square :) roof is 8.4m x 7.4m(laid flat)

Hi, i am currently in the middle of building a wooden workshop, all frame work is done. tomorrow the OSB boards are coming for the roof,the problem being, if i put them up and it rains before the roofing shingles arrive is the any type of waterproofing coating i can put on the boards...