Recent content by danfoss

Thank you. I'll get them followed- they seem to head under the floor boards to where the pump is.

Can the 3 port valve been in the loft? or any where under floor boards?

nothing like that near boiler or airing cupboard - will have look under floor boards (copuld it be near the pump?). Is it normal that the hot water cyl is red hot on the top and ice cold round the sides? The cold water feed seems to come from the water tank in loft str into the hot water cyl at...

where all my posts gone?

We can't guess what anyone has from the computer screen, but if you can tell us as much as you can then we can usually guide to where the problem lies. . Thank you for the reply: I have a danfoss controller (brand new), a baxi boiler, traditional cyl hot water tank, a temp controller in...

Aint' this same problem loads of us have, see: Heating on when only Hot Water switched on. I've gone through all site - loads of times this crops up - and so far still no answer?

The only thin I can find in there seem to be a temp controller fo rthe water cyl.

Its a danfoss 102e5 controller (brand new), Baxi WM51 3RS boiler, traditonal Cyl water

Cheers. Is it true there should be a summer value that can be switched off during summer - or someone pulling my leg? -------------------------------------------------------- Previous posts - anyone shed any light: ********'Check operation of electrical switch (black plastic housing) on side...

Since upgrading to vista from Xp I can no longer record what i hear on the PC. I've tried 3 differnt software - all 3 worked on xp but not vista. Any1 help?

Where is the electrical valve located?

I've still got same problem after replacing the controller - can someone please tell me what to check exactly? I have a traditional hot water cyclinder, heated by an element. I rang 3 plumbers today - all busy for the next week :-( where do I find this 3 or 2 port value? Near the boiler...

I had same problem - just in middle of changing my controller/programmer - if that helps. Mine is a traditional hot water cyclinder that is heated by an element not from the boiler as the CH, thus the problem seems to lie with the electrical signal not a pump

SPot on! thak you very much!!

Sorted thankyou. it has a small screw at the bottom - now removed!