Recent content by David Sarbutts

The supports around the edge is timber

Hi Madrab, it didn't have feet, but it had a riser kit. I will attach a photo of the timber supports. The tray was was supported around the wall and the base of the tray was on the floor. Any advice please of what to buy. Regards Dave

Can you still buy this type of shower tray? Any advice will be appreciated. Regards Dave

Hi, I've just removed an old shower tray and can anyone help me as to which tray I I should buy. The water pipes are coming from the floor. Photos attached Regards Dave

This is the house consumer unit

The supply is protected by RCD. I just wandered why it didn't have it's own unit in the garage. My garage is detached and my neighbour has a CU in theirs. Perhaps I don't need one.

Would it be safer to have some kind of circuit breaker in the garage or should I leave it as it is?

Hi, my garage has electrics, but has not got a consumer unit. It has 1 light switch and 3 sockets and was wandering if I should install a consumer unit? Can anyone tell me which consumer unit I should buy and would i be able to install it as I am not an electrician? Any advice would be grateful...

Thank you for your reply and advice. Regards Dave

Hi, I have a 2015 Ford Fiesta and the mileage is 50k. Can anyone pleas tell me, if my cam belt needs replacing and approx cost. Kind regards Dave

Hi, I'm going to replace my old shower tray. The tray is a high wall 800 × 800. Can anyone please tell me if you can buy the same tray as most of the trays I've seen are low profile and it worries me if water in the tray might overflow. Also, most of the drain holes are situated in the corner or...

Thanks all for your help

Thank you aveatry, that should do the job.

Hi aveatry, if my waste pipe is 22mm, can you get a reducer from a Ubend sink connection and connect it a 22mm pipe.

Thanks blub, what size is the sink waste connection or all waste connections the same size?