Recent content by Davidj6420

  1. D

    Replacing electric shower unit

    Thanks very much for the tip mate - I’ll pop the front fitting off tonight and twist them together for peace of mind. Cheers
  2. D

    Replacing electric shower unit

    Cheers Ebee - by that, do you mean ensure each of the wires have been wrapped around the screw once? I didn’t actually do this - just placed them right in and tightened the ever-loving sh*t out of the nut. Will that be okay?
  3. D

    Replacing electric shower unit

    In fairness, it was more the ‘whether I should screw the two Earth wires under the Earth screw’ which I was looking for assistance on, which the manual doesn’t explicitly state ‘if you have two Earth cables then connect them together’. Thank you for confirming that that is the correct thing to...
  4. D

    Replacing electric shower unit

    Mega D’OH! Can you tell I’m a novice?? No excuse either as I’ve read the manual front to back, back to bloody front in doing this! Cheers for the confirmation Taylortwocities.
  5. D

    Replacing electric shower unit

    Hi Terry, Photos of the unit and close-up of the incoming cable and Earth wires. For context, I’ve attached a photo of the old 8.5kw Heatstore Aqua Plus unit - both earth cables were in the Earth terminal when I removed the unit. Cheers
  6. D

    Replacing electric shower unit

    Hi Terry, Yes - will send pics this afternoon when I’m back home. Cheers
  7. D

    Replacing electric shower unit

    Hi all, Hoping for a bit of assistance. Have replaced an old electric shower unit with a Triton Riba 8.5kw unit. In the old unit, 1 live, 1 neutral and 2 earth wires went into the terminal block in the shower (the 2 earth wires went into the single earth terminal) On the new unit, am I...
  8. D

    Electric shower not receiving full power

    Hi, so recently my electric shower started running lukewarm at settings where it would usually run nice and hot. To get it to run hot, it has to be turned to higher settings, but with that, the water pressure drops significantly. I’ve also noticed that the half power light is no longer lit...
Back
Top