i thought it was a blocked feed but 2 of the radiators have clean water in them and have plenty of pressure to bleed them. I guess that means it can't be the cold water feed?
I drained my system to fit a towel rail. the water system did not appear to fill up after.
At first i thought it was a block in the pipe from the tank in the loft, but i have since discovered there is clear water and pressure in the system in 2 of the downstairs rads. There is still no...
I have a Salamander ESP 80 negative intelligent 2.4 bar pump.
Its a single pump that will feed the bathroom intending to pass through a pressure equalising valve to balance the mains cold.
I am going to get a plumber to fit this but I have had a few crazy estimates.
Could anyone give...
I dont seem to have much hot water presure with my hot water after fitting a thrmostatic hudson reed shower and a couple of single lever mixer taps.
I am 90% sure all my cold water is from the mains as the pressure is very good.
I think this then leaves me out of the standard dual feed...
Hi there.
I have just fitted a new bathroom, and have a conceald shower. The hose for the shower head is fixed and cemented into the wall.
Now the bathroom is complete I have attached the shower head. Once its turned on there is a leak where the screw attachment fitting has been...
Hi I am a new poster and have just purchased my first house!
I have A gas boiler going into a cylinder storage tank. The gas boiler is downstairs and the cylinder upstairs.
The radiators upstairs always seem warm or hot. Even when the heating and downstairs ones are off and cold. Is this...