Recent content by degsy b

  1. D

    Boiler problems after fitting trv

    Done valves both upstairs and downstairs but hardly any air come out..............do you think its advisable to drain the whole sysytem down again and restart..............advice please anyone
  2. D

    Boiler problems after fitting trv

    Thanks once again Stumpy.............as i live in a bungalow and therefore all rads are on the same level I will work from the furthest away the boiler and come back to the nearest to the boiler ....................will that be correct or should I work in reverse of that Cheers and thanx...
  3. D

    Boiler problems after fitting trv

    Thanks again Stumy.................and no ya not patronising...........all the advice is warmly welcomed.................................as I am getting some air out of all the rads every hr on the hr...........will this not solve the problem anyway by continuing to carry out this method or do...
  4. D

    Boiler problems after fitting trv

    Thanks for your reply Stumpy.................do you think air in those 2 pipes about 6 inches in length sticking up from the main CH pipes with those 2 x screw caps on are the cause of my poroblems????????? Degs
  5. D

    Boiler problems after fitting trv

    Thanks again Nickso, Got to admit a bit nervous to say the least on trying to release those two screwcap things espec when ya say not much thread on them and also if the seal goes water everwhere.................argh.................so looking for easier options i suppose Degs
  6. D

    Boiler problems after fitting trv

    Thanks Nickso.............will do.........................and if water comes out of them..............would you suggest my thought of draining 1 x rad of a few gallons without switching any other rads off would help - also would you recommend boiler on or off (to allow pump flow)for draining of...
  7. D

    Boiler problems after fitting trv

    Sorry if my mind has seemed to have gone astray...............do mean manual vents as in radiator bleeds or by those 2 x screcap things in loft???? Cheers Degs
  8. D

    Boiler problems after fitting trv

    the only way of clearing the air lock is as mentioned in my reply to corgiman a few posts above this............... do you think that may help....... Degs?
  9. D

    Boiler problems after fitting trv

    Thanks Nickso by opening them up will that release the air from the "primaries"??????????? Degs
  10. D

    Boiler problems after fitting trv

    Thanks again Corgiman.............when you say airlock in primaries what does that mean.............is it a good idea if it doesn't sort itself out to switch off CH and undo 1 x drain say kitchen and keep water draining until a few gallons have come thru...........would that sort it...
  11. D

    Boiler problems after fitting trv

    Thanks corgiman, Up in the loft I see 2 pipes sticking up with screw tops on (would use a screwdriver to release) attatched to CH system, tried to release them but they were very hard to say the least. so did not try other methods (molegips) incase i should not open them...............would...
  12. D

    Boiler problems after fitting trv

    hi folks, fitted trvs to all but 1 of my rads in my bungalow today, but after refilling system, bleeding rads and switching on boiler, the boiler goes into overheat and seems by sounds to be boiling, I have reduced the boiler temp from 3/4 max to now minimum this has helped a touch but to...
Back
Top