Recent content by digger1410

Laying engineering floorings is only as good as the sub floor to which you are laying. There are special underlays now with a very low tog rating and can be used in conjunction with a screed/concrete floor as long as it is flat and level. Flat is determined as 'when laying a straight edge...

Hi I would recommends screwing the 18mm ply to your existing floorboards, ideally locating the joists below as to not hit any pipes or electrics underneath. The new floor can then be nailed on top. Ideally use a porta-nailer see here...

I am creating a 3 new ringmains for a workshop. Each will have about 5 double sockets and up to 3 small machines wired through a 20amp fuse. Silly question time. Although not all machines will be running all the time, there will be a small occasion when they will be. 5 mins max. If...