Recent content by DrDan

Thanks for the Plumbase link, not heard of them. Turns out there's one 5 mins away, result!

I know, I know!! To be fair Tipper did say to try LS-X and bin the PTFE, I used PTFE originally but that didn't seal either. *hangs head in shame* Anyway I'm redoing the leaking joints with new olives and PTFE tomorrow. BUT I looked for some 22mm and 15mm copper olives but couldn't find...

So..stage one of fix. I bought some LS-X, took apart and inspected the leaky joints. I removed all the PTFE tape from both joints. - The bottom right brass olive was covered in places with a brown hard rust like substance so I gently used some wire wool to remove it until shiny again...

Morning! I've got 2 tiny leaks in my new pipework at the points arrowed. Top left - New compression fitting on 4 inch bit of 22mm pipe to a flexi hose. Used 5/6 wraps of PTFE on top of olive. No drips on the floor overnight but I can see a bead of water under the nut. Bottom...

Don't worry, MR PBs and full tanking will be in place...thanks for the comment.

Excellent! Many, many thanks for taking the time to read and post. Over the past few days I've come to more or less the same conclusions, it's just good for someone to confirm some of my findings. - Side wall of shower and toilet are both against external wall so no soundproofing needed...

Hi All, Ok it's not exactly tiling but it's preparation for it I guess... I'm doing a shower renovation and had a few questions about the battens needed for installing Aquapanel. * What size battens should go on the side wall, I'm thinking 50 by 25 (1x2) as I don't need to hide anything...

I'll post this in another forum...

Thanks, TeaTime... done.

Yes, JB will be above the kitchen cupboards but not hidden. Yes, RCD and 50A fuse in CU. Thanks for the advice you've given, it's much appreciated!

A minefield I see, I thought as much! OK...the cable currently comes through from above the kitchen cupboards and vertically down behind the tiles to the shower. - I guess I'll cut off the cable in the kitchen where it currently goes into the wall - The existing cable on the shower side...

Morning, I'm doing a shower renovation and had a few questions about battens behind the boards. * What size battens should go on the side wall, I'm thinking 50 by 25 (1x2) as I don't need to hide anything there, but 50x50 (2x2) at the end of the bath. Is this enough to route the pipes up...

Hi all, I need to move my existing electric shower about a foot to the right as I'm having a wider bath fitted and it's currently in the way of where the screen will sit. I'll need to connect about a foot of cable and the join will be behind tiled Aquapanel. The shower will only be used if...

Is there anybody......out there?

Morning, Bath and panels, screen, waste, rain shower, mixer, taps, shower mounting bracket all bought, there's no turning back now! OK, I'm going to batten and plasterboard the side wall as it's not exactly flat, and the same at the end of the bath - no chasing to hide the pipes, moving...