Recent content by emgee

Just to bring you up todate. Velcro would not stick to carpet or rubber, Also tried a small rubber mat from Wilkinsons with pointed dimples on the underside (as suggested by a neighbour). This slid around more than the original. Might try press studs next.

thanks ch427 and TicklyT I hoped Velcro would do the job. I bought some today before I read your replies. Got it from John Lewis and I was also looking at their press studs. Let's hope it's a case of great minds !!! Thanks again.

It's a nuisance and it's dangerous the way that the rubber mat gathers up under a drivers foot. Other than discarding the mat does anyone have an answer that they've tried and tested?

Steve I finally got round to trying what you suggested with the direct supply to the pump. After switching on and off eight times with no tripping I have to conclude it's not the pump. Could a faulty zone valve be the culprit? or do you have any other suggestions? Emgee

I thought that isolators for extract fans were only required if the fan was in zone one of the bathroom. Is that wrong?

Steve. Thanks for taking the time and trouble to deal with my problem. If I resolve it I'll let you know Regards Emgee

Thanks Steve My wife has reminded me that it has occurred when the microwave has been switched on or items switched on on one of the radial circuits. - but these happen much less frequently than when the heating or water is switching off which is almost every time! I hadn't appreciated...

Hi Steve, Original board had no RCD and was changed about 5 years ago. Boiler and controls installed 17 years ago,

We have a central heating system fired by a Potterton Neataheat Profile with Groundfus pump, Honeywell V4043 zone valves on heating and hotwater circuits,Landis & Gyr programmer and a Satchwell room stat. When the boiler is switched off due to programme settings or temperture changes it...

Just to resolve this query. I have replaced isolator and sorted problem. Thanks for help.

thanks spark123 and crafty1289. I have opened up isolator and connections look ok. Guess i'll just have to install new isolator.

I have a gainsborough 950 gsi instant shower which has worked fine for about 5 years. Normally the 40amp pull swith is left on but recently a visitor pulled the switch to the off position. When I switch it on again the neon illuminates but the shower fails to operate. When the shower switch is...