Hi I want to replace the waste on our cast iron roll top bath. It is rusted and staining the enamel, which we are planning on getting re-done.
Is this an easy job?Will I get a new waste to fit?
Thanks
Should I be considering this? The wall is tiled to half height. I want to tile to full height.
would it be feasible to plasterboard the untiled section...and then tile over the lot?
or should I rip off old tiles and start from fresh?
Cheers
Hello I want to install a shower,bath mixer type tap on my bath.However I have a 1930's stand alone roll top bath and the taps are mounted on the end of the bath rather than the top. Will I get a shower mixer to fit? Ive had a look but cant seem to find any.
Cheers
Hello I want to seal around my standalone roll top bath, on 3 sides.So that I can safely shower in it. Any ideas? At the moment it is just loads of sealent which looks terrible, thinking of a quadrant of some form..
A problem is where the round cornersof the bath meet the square corners of the...