Recent content by FredC

Hi Guy's final update, Sorted out the Magnetic Contact on Garage Door was in fact a simple wiring fault on my part thank god lol, got it wired the wrong way so changed the wires around and now all is well. Thanks for all the advice couldn't have done this job without the help from this forum...

Okay Secureiam Re-checked and re-set the zones 1 and 2 and all is well alarm working fine the only problem that I'm left with is the magnetic door contact is not working for the garage side door will check the magnetic contact with continuity tester and if all's fine with the contact I will...

What you've said is correct the door opens and the entrance PIR starts entrance timer but goes wrong when I enter the hall I'll check the zone again but I'm sure it was set on Inhibit and I'll test it again tomorrow can't test at moment to many people in the house. Will let you know how I get...

Hi Secureiam Bear with me the entrance into our house is PIR no magnet contact and the same for the hall where the keypad is located I've got the entrance PIR on timed and the hall PIR on Inhibit, hope you can understand Fred

Hi Deryck Okay had a little time on my hands so I changed the zones around the entrance/kitchen is now zone 1 the Hall (where keypad is located) is zone 2 and i moved garage side door to zone 3. Set alarm and went outside for a couple of minutes came back in and all was well in the kitchen...

Okay Thanks for all the help Deryck will change to zones around at the weekend and let you know how I get on fingers crossed. Fred

Okay Deryck I think I understand now so the Kitchen has to be timed and the Hall Inibit no problem in changing the zones around BUT........ in zone 1 is my Garage side door that I've fixed magnetic contact. Will this be okay to move only somewhere in the manual I think I read magnetic contact to...

Thanks For the replies guy's honda that link does nothing ? if it's the Engineer's manual I already have that but to be honest I can't make head nor tail of it. EightyTwo not a clue what RTFM means that's a bit like the Engineer's manual hard to understand. Deryck thanks for the reply...

Hi all New to the site need a little help installed a Accenta G4 mini with LED remote keypad, I've got the keypad located in the Hall when I set the alarm I have to walk through the Kitchen to exit the property, am I right in thinking that I will need to set up exit / entry times for the Hall...