Recent content by frznmrtn

i was gonna use 4x6cm wooden battens to make a frame and hang door on them. but now i have to use someting like 4cm by 8-9cm to reach the brick bit on the wall. other option i can think of is , move the frame about 4cm in to the alcove but that does make the cupboard smaller and it is not gonna...

there is no sockets or plugs near by , it is and upstairs room so i dont think there is any gas pipes going along (vertically) the edge of the chimney breast but then again what do i now :?

it is near the edge of the alcove, i want to believe:) that it is a plaster beading. but i think i ll drill a bit further than the egde and see what happens.

Thank you for your reply Joe-90. so is it ok to drill into that? or rather is it possible to drill in to that?:) do you think i should try and find new position for my frame? Many thanks.

hi, i hope someone can help me with this, i am quite a novice on DIY. i am building a fitted cupboard in to the alcove. when i tried to drill into the side of the chimney breast to attach wooden batten for my frame, after half and inch into drilling i hit something metal. what could it be? can i...