no i just "went for it" wether it was a jigsaw / circ saw or hand saw I just tried to keep the blade against the joist, this is what Im after tips/tricks/tools to do the job
Hiya lads Im back :wink: ,
Ive fekked up :oops:
Spent the last few days bustin' ma balls, getting to the final stages and cutting the boards to fit the frame and the circular saw I was using cut right into the frame so Ive ruined about 3 boards and will have to lift and replace them...
thanks lads,
now what about cutting the square edges out of the boards for the newels, whats the best tool/method as I can see a problem if I cut two straight lines into the board how would I cut the bottom bit out to effectively remove that piece of board from the rest, hope you understand...
Hiya Everyone,
Probably will be starting to lay my boards tomorrow onto my frame my question is do I start at one side and work my was across or do I lay one at one side and one at the end and fit the remaining boards in-between?
May seem like a daft question but Im concerned that I start...
Hiya Lads,
An update for anyone interested......It Worked.....!!!
Drilled out the dowel with a 32mm flat wood bit, however the Mrs was near screwfix so I told her to grab another 3 of their cheapy £1.56 32mm drill bits as they where going blunt after each post
Hope this helps someone in...
Hiya Lads,
Thanks for the replies, this afternoon I paid a visit to the local timber merchant and picked up some 25mm x 2000mm (£4.25) dowel which Ive cut to size and glued with Blue Evostick Wood Glue, says it takes 24 hrs to dry so I wont try anything else with it till tomorrow afternoon...
hiya mate,
The posts have not been fixed in yet so they are just laying around in the shed however they are sculpted at the top so I cannot turn them over or around as they also have a section cut out the bottom to attach them to a joist.
Is there anychance you could link me to a suitable...
thanks for the reply John.........!!!
I was hoping for an easier answer :(
The holesaws did not look deep enough the posts are 85mm deep
Would buying some 25mm dowel do the trick then using my original 32mm flat wood bit work?
regards
Hiya Im Back.... :lol:
Things are progressing but Ive just hit another snag, I bought some 24mm manila rope and drilled 25mm holes through the posts however when I came to thread the rope through theres not a chance in hell it will go through so I put my next drill bit in from 25mm to 32mm...
hiya,
thanks for the reply....!
The newel post (first and only one so far) is in the corner and has two coach bolts going through it one through each joist one higher and one lower (hope this makes sense)
The post had a large cut out notch which I chopped off.....!, as I thought that bit...
Hiya Lads,
Attempting my first deck and looking for your wisdom please
Ive constructed a frame roughly 3.6 x 3.0 mtr with internal joists every 400mm
Its laying on fairly rough ground Ive packed slabs under it to support the bigger gaps, now I attached my first newel in the corner with 2...