Recent content by gasgas

My church kitchen has one of these and they have turned it off because of what sounds like a PRV leaking. I admit I haven't taken the cover off yet to have a look but when I searched for a manual or a source of spares all I could find was the word 'obsolete'. It is 'possible' that I could...

Good grief what a mess. And there was I, sometimes thinking to myself in the middle of a difficult install, that a Really Good installer would have done it neater. Now I can hold my head high and be proud of my plumbing. At least I know which way is up, how to solder end feeds, and I can read...

Thanks Alan and nozzle. I call that stuff gunge tape. I did think of it, but on the first job I did at this house I didn't think it was feasible for some reason. Anyway on the second occasion, because of the expense of the electrical insulation gel I used the first time, I have used gunge tape...

My daughters house has all the copper CH pipes buried in the concrete floor, so of course they are corroded and leaking. I have replaced the copper with plastic, but where the copper pipes disappear into the brick room dividing walls I can't do that without removing bricks, which I don't want to...

truma heater

Vulcan

UV twin coil cylinder heating with IG boiler

Anyway what about the Dual Mass Flywheel and the starter motor with its own internal gearbox? No longer does the ignition switch send 12v to a relay which sends 12v to the starter motor. The ignition switch sends a 'wake up you lazy bar steward' signal to the ECU. A few seconds later the ECU...