Recent content by gasmanTim

Thanks for your help i know time is at a premium. There have been no call backs and have contacted them and its not happened since the last visit. All the rads were open so its not as if the closed rads were diverting else where. The only thing i could think of is that she had been messing...

Thanks for that . Im not part P and work with my sparks all the time to share the work load. I would like to be able to do some more wiring and get my part p eventualy..........but its time and its mid heating season .Most of my works are combi swaps and he even wires up the programmers and room...

Hi thanks for the reply. I am sure the valve is working as on the drayton i can see it slide from dhw to mid to heating. The sparks testing is confirming this with his testing equipment.;

Hi and good morning. I have been back to the property and fired the hot water up with temperature probes on the flow and return on the offending rads.............monitored temperature for about 30 minutes and there was no change in flow or return. Heating on flow gets hot with return being...

Thankyou very much. I will try this tomorrow.

I see where you are coming from but this would be periminant and not happening now and again. The mid posistion valve moves over on demand and i can fell the pipe on the clinder flow warm as the valve moves over and the return on the cylinder also starts to warm .Same goes for the valve...

Sorry ,do you mean part of the heating circuit plumbed in to the cylinder return .There has been an extension added about ten years ago i dont know by who . I will say it only affects upstairs from what i gather.

I couldnt get the old system up and running it was partially filled and the boiler was a real state ie control board hanging of etc.

Thanks for your replies realy kind. im not sure on the reverse flow on the cylinder return because this problem is intermittent it only ever happens after 1500 hrs if at all. The mid posistion valve body and actuator is brand new so i don't think its this. It moves into required posistion on...

Hi i hope you can help because i am stuck. I have put a new worcester 15ri on to an old system with a drayton mid posistion valve. The stat and programmer are honeywell 9000...2 channel. The problem is that when the hot water is on and its set to come on three times a day the rads also come...